strike plate การใช้

• The hinges and strike plate are often reinforced with long screws.
• Now turn the dead bolt latch again until it hits the strike plate.
• The screws holding the strike plate should be at least 2 inches long.
• The strike plate is activated when a player pulls a trigger in the club handle.
• Retract the dead bolt once more, swing the door open, then look at the strike plate.
• Deadbolt locks have strike plates that are mounted flush in the surface of the door jamb.
• "Sauder " is imprinted into two metal strike plates, located in the corners of the upper doors.
• Backface deformation is the effect of a non-penetrating projectile on the rear face of a strike plate.
• The bolt is a metal rod that extends from the door into the strike plate on the jamb.
• Once all the cutting is finished, screwing the lock and strike plate in place takes about 10 minutes.
• Check the positioning of the strike plate, which is the metal plate over the hole in the door jamb.
• The hardware fastening the lock to the door and fastening the strike plate to the jamb should be sturdy.
• The strike plate ( the part that fastens to the door frame ) should be attached with 3-inch screws.
• The strike plate to ignite the match may contain one more of the following : glass particles, red phosphorus and glue.
• That sets off the explosive charge, which in turn releases an expanding gas that moves a piston that controls the strike plate.
• The club has a strike plate in its head, which when triggered rockets out about 2 inches to launch a golf ball.
• When I left the door ajar or tightened the latch so it wouldn't rattle in the strike plate, the sound stopped ."
• Pry the stop molding off, then close the door until the latch bolt just clicks into the hole in the strike plate.
• You will also have to mortise the edge of the door and the jamb to receive the bolt mount and the strike plate.
• He took a 3-and-2 pitch in the eighth inning, perhaps an inch inside, perhaps a strike plate umpire Jerry Crawford couldn't bear to call.